11
AD D Z - W AV E D E V I C E S
Devices should be powered and in their final location prior to inclusion. To add new Z-Wave device:
1.
Tap
Add Device
. Wait for the status message field to indicate "
Add Node Started - Press
Abort to Cancel
". If you wish to terminate the Add Device action, tap the
Abort
button.
Note:
Depending on the IBR-ITAB firmware version, the device list may include an entry with the De-
scription "
Napco Controller
" (also includes the
NodeType
"
Napco P
"; see image below). This
entry is the IBR-ZREMOTE module, with its integral Z-Wave primary controller.
2.
Press the "Learn" button on the device.
Note:
Z-Wave device designs can vary, including the
name, location and operation of its "Learn" button (some require one button press, others require
two); see the documentation for the specific device you wish to add to ensure correct operation.
3.
Wait for the
NodeType
,
Description
and
Status
of the de-
vice to appear in the table.
For example, adding a light switch may indicate "
Switch
"
as the
NodeType
, "
Switch1
" as the
Description
, and
"
Active
" as the
Status
.
Test the new device:
In the
Test
column, tap the button
(or "arrows" for a dimmer) as required. For example, the
Test
column for a switch device will toggle "
ON
" and "
OFF
"
buttons.
Once all devices have been added, tap the "back" arrow (at
the top left) to return to the
Automation Management
screen.
Note:
Devices that are being re-enrolled in the
same network (or were previously installed in another net-
work) must be "Removed" prior to performing this "Add" pro-
cedure. Therefore, perform the "Remove" procedure on the
device even if it does not appear in the table.
(Above screen displays appearance before adding Devices)
Add Node Started - Press Abort to Cancel
"Back" Arrow
Z-Wave
Device
Setup
