GEM
-
TOUCH
K Style
Keypad Operating Guide
17
F U N C T I O N M EN U
Mode and when "
DEACTIVATE CHIME
" is displayed, tap
Enter
.
Note:
The
Chime Mode is disabled while armed. Chime is disabled for
Protected
zones
while armed,
Never Armed
zones (such as a driveway sensor) will continue to
chime when system is armed.
Activate Fault Find?
At the initiation of a test, the control panel sends a message to the central station
that a test is in progress, and normally causes all zones to give a 7
-
second beep
at the keypad(s) when any zone is faulted or restored. On completion, a ring
-
back will be given. Fault Find can not be initiated when the system is armed,
and all reporting is inhibited while in Fault Find. Keypad will display the following
warning that the system is in Fault Find: "
FAULT FIND RF SIG POWER
-
-
".
If a 24
-
hour zone is open at end of the test, no report is sent. If a 24
-
hour zone
is tripped and not restored during Fault Find, when Fault Find ends, the zone will
display as "Faulted" on the keypad display. When Fault Find is exited (tap/hold
-
down
Reset
, enter your User Code and tap
Enter
), a Fault Find Restore Report
will be sent, and upon completion of the report a ring
-
back will be given.
Activate Locate?
This feature helps you find zone troubles and indicate when they are repaired.
When initiated, the sounder will turn on and the keypad display will read
"
LOCATE
", then tap the
Up
and
Down
buttons (as displayed on
-
screen) to scroll
through the zones in trouble. As each zone is corrected, the sounder will stop mo-
mentarily, signaling its repair, and the display will indicate the remaining zones in
trouble. The sounder and display will continue in this manner until all zones are
repaired, or until
Reset
is tapped/held
-
down and a User Code entered (to exit).
A C T I V A T E F A U L T F I N D
Y / N
A C T I V A T E L O C A T E
Y / N
