NAPCO GEM-RP8LCD, Руководство по эксплуатации

Страница: 23 / 32

23
S Y S T E M T R O U B L E S
Your control panel is capable of detecting a variety of troubles that may affect system performance. In the unlikely event that a
problem should occur, the SYS TBL (system trouble) icon will display on the left side of keypad window along with one or more of
the following Trouble Descriptions. If the problem is related to a specific zone or device, the corresponding number will also be
indicated. Below is a list of the most common troubles along with the necessary corrective action, if any. If a message appears
that is not listed below, call your security professional for service. When a system trouble occurs, the keypad can be silenced and
the display can be cleared by pressing
C
. The system can then be armed and disarmed as usual.
Note:
If you cannot clear a system trouble yourself, call installing company for service as soon as possible.
System Trouble
Indication
Action
AC Failure
This trouble will occur if AC power is not present. Make sure system transformer is plugged into AC
receptacle and check the circuit breaker, otherwise call installing company for service.
Low Battery If there has been a recent power failure, the battery may be partially depleted and must be recharged
by the control panel. The control panel performs an automatic daily test of the battery, at which time
the trouble will clear if the battery has been recharged. If the trouble does not clear in 24 hours, call
installing company for service.
Fail to Comm The system was not able to report to central station. If this is due to a temporary interruption in the
telephone service, the trouble can be cleared when the service is restored by performing a
Communication Test:
1. While disarmed, press
R
.
2. Press
R
until “ACTIVATE DIALER TEST” appears in the window.
3. Press
U
to send a test signal to the central station.
If the trouble continues, call installing company for service.