NAPCO GEM-RP8LCD, Руководство по эксплуатации

Страница: 10 / 32

10
Disarming the System
1 Enter your premises through the Entry/Exit door. The keypad will sound a steady
tone to remind you to disarm the system before your Entry Delay time expires.
2 Enter your User Code and press
U
. The red ARMED light will go out, indicating that the system has been disarmed.
•
If you enter an invalid code, the keypad will sound two tones, signifying an error. Re-enter your code immediately.
•
10 seconds before Entry Delay expires, the keypad will emit a pulsing warning tone (if programmed by your alarm
installer).
Alarm Indication / Silencing an Alarm
If the red ARMED light is flashing and “ALARM” is displayed, an alarm occurred while you were out. Proceed with caution! If
you suspect that an intruder may still be on the premises, leave immediately and call authorities from a neighbor's phone.
To silence an audible alarm:
1 Enter your code and press
U
. After the system is disarmed, the window will continue to display “ALARM MEMORY”
followed by the zone(s) violated.
2 To reset the alarm memory display, note the zones violated, then press
C
.
Ambush
(Optional - Ambush programmed? ! YES ! NO) (Your Ambush Code is __ __ __ __)
The Ambush Code (optional) is a special 4-digit code that is entered in place of your normal code. If an intruder forces you to
disarm your system, enter your Ambush Code and press
U
.
This will send a silent alarm to the central station. The red ARMED light will go out and the window will display “SYSTEM
READY”, as if the system were merely disarmed. There will be no indication that an alarm has been sent.
T U R N I N G O F F T H E AL AR M ( D I S AR M I N G ) W H E N R E T U R N I N G
D I S A R M N O W
X X X S E C O N D S