NAPCO GEM-RP8LCD, Руководство по эксплуатации

Страница: 18 / 32

18
P R O G R AM M I N G ( O P T I O N A L )
automatically saved.
Repeat steps for each User Code to be programmed. While in User Program Mode, the Armed, Status and SYS TBL display
will continue to flash. Follow the example below to program
User 2’s code to 1923.
User Program Mode Example:
1. Press
2
(Keypad beeps twice).
2. Enter
1 9 2 3
. The keypad will beep four times confirming a valid entry. The keypad will automati-
cally save the new User Code for the user number, and reset to allow a new user number to be programmed (or repro-
grammed).
Note: A two or three digit User Code can be used by entering zeros in the last digits. For example, “37” can be used by
entering “3700”. For another example, “373” can be used by entering “3730”. This feature applies only to the GEM-
RP8LCD, not the GEM-RP8 keypad.
Changing or Canceling a Code:
To change any User Code, merely program over the existing code. To cancel a Code, press the number of the user to be
deleted and press the
Q
key. The User Code associated with the user will now be canceled.
Exiting User Program Mode
To exit User Program Mode press the
C
key.
•
While in User Program Mode, the ARMED and STATUS lights will continue to flash and burglar and fire alarm functions
are disabled.
•
In selecting your codes, do not program repetitive numbers (1111), consecutive numbers (1234), your birth date,
address, or other obvious combinations. If the keypad detects no Program Mode activity for more than 4 minutes, a tone
will sound. Press
C
to silence.