Napa Technology Customer Support 800.603.6550
a.
Open the bottle
and place it on a
flat, dry surface
.
b. If you have a
Head Selection Tool
(see photo), insert it into
the bottleneck to determine the correct gasket size.
If you
do not
have a Head Selection Tool, try inserting
different heads into the bottle, from wide to narrow (green,
red, white), until you find the correct size that fits.
Note:
• The gasket should be fully un-tightened (collar all the way
up, touching the main body) before you insert the head.
• The correct sized gasket should go into the bottle easily,
with one arm extended forward. Do not lean on the head
or use force, as this may damage the gasket.
c. Take a clean dispensing head of the size you selected. Check that the gasket is in
good condition, the cap is properly mounted, and the rotor switch is in the correct
position. (See the “Cleaning and Care” section for more details).
d. Insert a clean
pick up tube
into the bottle. (It is normal for the upper end of the tube
to extend beyond the tip of the bottle at this point).
e. Insert the
upper end
of the pick up tube
firmly
into the opening on the bottom of the
head, as shown. (Keep the rest of the tube inside the bottle while doing this).
Page 14
Head Selection Tool
f. Carefully insert the dispensing head (with
the pick up tube attached) into the bottle.
The head should go in easily with one arm
extended forward. Do not lean on the head
or force it in, as this may damage the gasket
and/or the top of the glass wine bottle.