Napa Technology Customer Support 800.603.6550
Page 9
1. Unpack the WineStation
Unpacking and Installing your WineStation(s)
a. Move the box to the installation location. Note: the WineStation is packed upside
down. You will need to roll the box over and lift it up, before you can access the
WineStation.
b. Open the top of the box and remove any loose accessories such as the drip trays
and regulator (if you have not already done so). Do not remove the protective
foam packaging.
c. Fold one of the top flaps outwards and roll the box onto that side. The flap
should now be folded under the box.
d. Fold the remaining three flaps outwards, and carefully roll the box one more time.
The open side of the box should now be facing down, and all four flaps should be
facing outwards.
e. Carefully lift the box upwards. The WineStation should now be standing upright
inside the foam packaging.
f. Remove the top part of the foam packaging from the WineStation.
g. Remove the film from the door and WineStation label, if not already removed.
i. To remove any glue residue, rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and dry.
ii. Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or residue. These products can damage
the surface of your WineStation.
Excessive Weight Hazard!
Your WineStation is heavy (see Product Specifications).
Always use
two or more persons
to move the WineStation
Failure to do so can result in serious back or other injury.
Protect your Counter top / Installation Area!
When moving the WineStation for installation, cleaning
or service purposes, be sure to protect your counter top.
Always lift and pull the WineStation straight out when
moving it. Do not wiggle or walk the WineStation, as
this may cause counter top and/or product damage.
