Nanni Q2400 Series, Руководство пользователя

Страница: 61 / 110

61
S 07 MAINTENANCE
fuel filter by a few turns. Open fuel bleeding cock ( 2).
Engine with the electrical fuel feed pump
Turn the key to the AC position and supply the fuel with
the pump for 10 to 15 seconds.
Engine with the mechanical fuel feed pump
Set the stop lever on STOP position and crank the engine
with the starter for 10 to 15 seconds.
Close the air vent cock correctly after you bled the air.
Tighten the plug (1) when the bubbles do not come up.
Close the air vent cock ( 2) on top of the fuel injection
pump.
NOTE!
Always keep the air vent cock on the fuel injection pump
closed unless when you release the air. If not, it can cause
the engine to stop.
ENGINE FLEXIBLE MOUNTS
On new gensets or on gensets that are out of adjustment,
make sure that the front and rear flexible mountings are
set properly.
Check that the four flexible mountings are correctly posi -
tioned, then fix the mountings to the engine bed.
Twist or stress on the rubber mountings is not accept-
able.
CAUTION!
Flexible mounting must be replaced every 2 years.
Respect the minimal value H (8mm - 0,315 in.); if the val-
ue is below replace the engine mount.