Nanite systems DAX/2, Инструкция по эксплуатации

Страница: 9 / 41

The DAX/2 System – Version 8.0.5
9
To reboot your unit:
 Via the remote console
, type the following:
shutdown -r now
 Via the display screen or teletype interface
, select
reset
from the main menu.
Tip : if you do not want to shut down your unit immediately and have remote console access, you can substitute a number of
seconds for the keyword “
now
” when supplying parameters to the
shutdown
command.
shutdown
also supports can-
celing a scheduled shutdown or reboot (with the
-c
switch) or sending a fake shutdown warning (with the
-k
switch.) If no
time is provided, the unit will automatically shut down in 30 seconds by default.
Replenishing the battery
There are seven supported methods for recharging a unit’s battery, five based on fixed-place equipment meant to charge
units conventionally and two which are recommended only for use during emergencies.
The standard methods are:

Using an
NS Charging Platform
or
Recreational Cybernetics Platform
:
1. Place the unit on the platform either manually or under its own power.
2. Press the
charge
button on the platform’s touch screen.
3. The charger will automatically engage. Charging may take up to 16 minutes depending on the battery’s
condition and capacity. If you wish to terminate charging prematurely, press the
abort
button on the touch
screen.
4. After the charge cycle completes, press the
disconnect
button on the screen. The unit will automatically
release.

Using an Autonomy Control Systems Charging Platform :
1. Place the unit on the charging platform. It will receive a control menu.
2. Instruct the unit to select ‘ Charge ’ from the menu. If the unit does not receive this menu, touch the pad
yourself to access its controls.

Using a
Destruir Technologies Wireless Charging Station
:
1. Instruct the unit to press its hand against the charging source. It will receive a control menu.
2. Instruct the unit to select ‘ Charge ’ from the menu.

Using an
NS Upright Display Booth
,
NS Demo Stand
(version 2.1 or later), or a
UMD Charging Platform
, in-
cluding QETESH Charging Platforms:
1. Simply stand the unit on the display platform. It will passively charge from the platform as long as power is
connected.
The emergency methods are:

Using an
NS Pulse Charger
:
1. Power down the unit.
WARNING : Exposing active electronics to the Pulse Charger field may cause disruptions.