The DAX/2 System – Version 8.0.5
16
7 Remote access
Pictured above
: The System 8 remote management console shown in its ‘disconnected’ and ‘connected’ states (top and
bottom, respectively.) Sold separately.
Connecting to a unit
To connect to a unit, press the
connect...
button. After 4 seconds, a list of available units will appear. Note that the console
will be otherwise inoperable while scanning.
Scanning nearby units without connecting
To view the nearby units, press the
scan...
button. The scanner will be active for 4 seconds. Note that functions on the con-
sole other than menu and terminal input will be inactive during this time. The scan output will include version numbers,
which are of importance: only units running version 8.0.5 and newer can be controlled using the remote management con-
sole. Older units will only support public announcements (if chorus mode is enabled.)
Sending a public announcement
Press the
broadcast...
button, select a range, and enter a message (up to 250 characters.) Messages broadcast with unlim-
ited range will be sent through all units in the region.
Issuing a command to a single unit
Press the
command...
button and enter the command you wish to execute. To make the unit act or speak, use the
relay
<message>
command. For a list of other commands, see page 35.
Note
: The unit may not respond at all if the command is
rejected for security reasons, so it is advisable to perform a test command (such as
help
) after connecting.
Содержание DAX/2
Страница 41: ...nanite systems com 1 800 5 NANITE 562 6483 ...