NANAWALL WD66 OWNER’S MANUAL
10
Step A10
Anchor the side jambs to studs or walls. Make sure that
the jambs are plumb and straight.
Be aware that the anchorage points in the side jamb with
the lesser number of panels attached to it may in Step C6
need to be loosened to be able to move the side jamb to
adjust the total width of the unit.
Step A11
As the sill is attached first, then the side jambs, now
anchor the head jamb through the pre-drilled holes and
shims. Make sure that the head jamb is level.
IMPORTANT:
Make sure no shims are forced to
ensure that frame sections are not bowed. Check
frame constantly to be certain that it is level,
plumb
,
and square. A transit and other similar precise
measuring equipment should be used to make these
determinations.
Step A12
IMPORTANT:
Make sure that all the surfaces of the
upper and lower tracks are clean and free of any
debris, especially, cuttings from drilled holes. See
Illustration A3.
B. PANELS AND FOLDING HARDWARE
INSTALLATION
IMPORTANT:
Look for glass stops to determine the
interior side of a panel.
Step B1
On top-hung WD66/o insert all the upper running
carriages into the upper track, through the slot on
one end of the head jamb. The lower running carriage
functions as a guide in the sill. See also Diagram 2.
On floor supported WD66/u insert all lower running
carriages into the sill. See Illustration B1. The upper
running carriage is just a guide in the upper track. See
also Diagram 2.
Step B2
Looking at the elevation drawing, first install panel(s)
hinged to the side jamb(s). Align the hinge components
on the panel to the hinge components on the side jamb
and insert the proper hinge pin. Insert the hinge pin in a
way such that the security set screw fit into the groove in
the hinge pin. Loosen the set screw as needed to insert
the hinge pin, tighten till it touch the pin and then back off
a full turn. Use an Allen key. See Illustration B2.
ILL. A3
