16
NAISHKITES.COM
V - CONTROL SYSTEM BAR
1) ADJUSTING FUSION BAR STEERING (REAR) FLYING LINES - Continued
E) Pull the knot out of the locking cavity (1).
F) Adjust the leader line to the desired knot using
the adjusting cavity (3).
G) Lock the desired knot securely in position using
the locking cavity (1).
H) Feed the end of the leader line back through the
adjusting cavity (3).
IMPORTANT:
Repeat this procedure on the opposite
bar end so the leader line length adjustment is
done exactly the same on both sides.
I) Lock the following knot securely in position using
the locking recess (2) and insert excess line into
the adjusting cavity (3).
K) Reinstall bar/line adjuster by pushing it back
into the bar end, while pulling leader line above the
floater to remove any slack as shown.
