18
NAISHKITES.COM
Step 1:
Using a flying line, pull the bar adjuster up
as shown.
Step 2:
The leader line knot holds the bar adjuster
in position, so you will need to pull the leader line
through the bar end slightly to loosen the bar
adjuster for rotation.
Step 3:
Rotate the bar adjuster 180 degrees.
Step 4:
Reinstall the bar adjuster by pushing it
back into the bar end, while pulling the leader line
above the floater to remove any slack.
IMPORTANT:
Repeat this procedure on the
opposite bar end so the bar width adjustment is
done exactly the same on both sides.
V - CONTROL SYSTEM BAR
4) ADJUSTING THE BASE BAR WIDTH
To connect the Smart Loop and Chicken Finger to
the harness hook:
Step 1:
Hook the Smart Loop onto the harness hook.
Step 2:
Insert the Chicken Finger into the center section
of the harness hook.
To disconnect the Smart Loop and Chicken Finger
from the harness hook:
Step 1:
Pull the Chicken Finger out of the harness hook.
Step 2:
Unhook the Smart Loop from the harness hook.
The Chicken Finger is designed to hold the Smart Loop in position in the harness hook.
WARNING:
Make sure the Chicken Finger is
positioned below the Smart Loop and is completely
inserted into the harness hook.
VI - SMART LOOP
1) OPERATING THE CHICKEN FINGER
WARNING:
To release yourself from the kite in an emergency situation, you must activate the Smart Loop Quick
Release when the Chicken Finger is installed.
