Nagel Foldnak 100, Руководство по эксплуатации

Страница: 12 / 36

© Ernst Nagel GmbH 9965043 Operations manual Foldnak 80-100 Trimmer 100.doc Rev.1.3 23.10.2006 12
Adjust 1a
Width +/-0.0
-
+
-
+
Adjustment of fold position
Adjustment of staple position
Submenu 1
Paper format
Attention ! Before every change of format check stapling head position. Danger of collision!
Small format : remove leaf springs from the side guides! Below a width of 152mm with a stapling head
distance of 75mm. After operating in small format reattach the
leaf springs
tight and parallel to the
side guides.
Smallest format (A6): install the kit for the smallest format (A6), see the manual enclosed the kit.
Remove support plate of S 8, mount attachment infeed funnel and infeed funnel left and right.
Use the special paper downholders.
Predefined formats like A5, A4, A3 or customized C-formats are selectable. Inch formats like Statement,
Executive, Letter, Legal and Tabloid are selectable after the dimensions have been changed from metric to
inch.
Adjust
If you notice during the jogging procedure that the paper seems to bee too
large or too small it is possible to adjust width and length of the format
setting.
Staple and fold position are also adjustable.
You have to enter the deviation from the basic setting.
Adjust the +/- first by using the up/down keys and confirm it with
the enter key. Search by using the up/down keys the correct value
(for each digit) and confirm it with the enter key. The enter key
moves the cursor one position to the right.
It is recommended first to adjust the position of the fold and then to
adjust the position of the staples.
Reset Counter
After having confirmed the question “sure?” you can reset the batch counter.
Operation mode
Here you can set if the paper is coming from a S8, a RoboFeeder or is fed manually. Also the finishing mode
of a booklet or a block is set in this submenu.
Delivery
In order to improve the booklet stream on the delivery the delay time of the delivery belts is adjustable.
The adjustment of the delivery in the menu is only possible, if the delivery is directly connected with the
Foldnak. At the Trimmer it is adjustable with the potentiometer, at the SP+ it is not adjustable.
Trimmer
Offset (of cutting width)
Offset defines the width of the waste.
Trimmer modes
You can set a tick mark to tell the Foldnak that a Trimmer is connected. You can tell the machine the same
way what is supposed to be done with the booklet. Not trimmed in the bypass mode or trimmed.
STOP-Pos.
The delay of the belts can be adjusted. This can be necessary if a booklet jumps back from the trim stop.