Nagel Foldnak 100, Руководство по эксплуатации

Страница: 16 / 36

© Ernst Nagel GmbH 9965043 Operations manual Foldnak 80-100 Trimmer 100.doc Rev.1.3 23.10.2006 16
Selection of staples and driver blade
For very hard sheets or thick paper blocks (above 15 sheets 80 gsm) it is recommended to use 26/8S
staples and the flat driver blade.
Change from flat to loop staples
To change from flat staples to loop staples the driver needs to be exchanged, if the flat driver blade is
installed. See SH-change (Hohner: page 14, Nagel: page 18).
For a
change from loop staples to flat staples the driver doesn’t need to be exchanged, unless very hard
sheets or thick paper blocks are processed (above 15 sheets 80 gsm).
Block stapling
The paper block is jogged against the staple stop when block stapling. That means the unstapled side of the
block is the leading edge. Please consider this orientation, when loading the collator.
A sheet metal ramp which guides the block into the transport belt after the fold rollers needs to be installed.
The side guides are opened automatically in order to allow the block to be deflected into the transport belt.
To insert the ramp remove the upper belt (fig. 2 and 3), then insert the ramp with both narrow guide fingers in
the table. Push the ends down (fig.4). After finishing, put the belt back in its place.
1
2
3
4