Nagel Foldnak 100, Руководство по эксплуатации

Страница: 13 / 36

© Ernst Nagel GmbH 9965043 Operations manual Foldnak 80-100 Trimmer 100.doc Rev.1.3 23.10.2006 13
Settings Foldnak 80/100
Attention! Adjusting the Foldnak-parameter during operation may cause disruptions!
Customized Formats (C-Formats)
Definition of customized formats. Minimal: 105 x 140/ 4.14 x 5.50, Maximal: 364 x 521/ 14.33 x 20.50 resp.
461/ 18.15 [mm/inch]. Choose a C-Format and press enter twice. Search by using the up/down keys the
correct value (for each digit) and confirm it with the enter key. If the length is choosen, it jumps to the menu
item width. Finish it with the back key. To select a customized format it needs to be choosen in the paper
format menu. See paragraph “paper format”. Check stapling head position!
Language
The selection of different languages is possible.
Dimensions
Here you can change from metric to imperial dimensions. The display will show a question mark after a
change. It means you need to choose a paper format. There is a differentiation between fine and rough
adjustment. In the menutable it is marked with one * and two ** asterics. In the fine adjustment means
0.1 = 1/256 inch, rough adjustment means 01 = 1 inch. See little table below the menu table.
Service
This part is password protected and meant for the use of service technicians only. Attempting to perform
repair and replacement procedures w/o proper training may cause machine damage or operator injury.
Speed
The speed of the Foldnak can be set for
S8-operation
(sets per hour):
S8: continuous
with SP+: 1,000 compulsory (will be improved)
slow: 500-1,100 / 1,000 range / recommended initial value
medium: 1,200-1,800 / 1,600 range / recommended initial value
fast:
1,900-3,000 / 2,300 range FK100 / recommended initial value
2,000-2,500 / 2,300 range FK80/ recommended initial value
It is recommended to start e.g. in the medium speed with the initial value of 1,600 and than to increase it.
Speed of the Foldnak,
RF-operation
(sheets/hour):
slow and medium: up to 6,000
fast: above 6,000
The maximum of the FK depends on paper type and format and amout of pages of the booklets.
Clearing
There are three choices: a) booklet, that means stitch and fold, b) open the side guide and c) eject, that
means only folding.
If an error occurs, the Foldnak jumps automatically to this menu item.
Additional mechanical corrections at the Foldnak
The clearance between the fold rollers can be adjusted w/o tools. The
knurled screw needs to be loosened, see arrow in the picture. For
sensitive paper rather set a wider clearance, that means to turn the
screw in the direction of the infeed. It is important to set the lever on
both sides similar.
The pressure of the fold rollers can be reduced for sensitive paper. And
it can be set subtler by using a weaker spring. The pressure must not be
increased, because a thicker booklet may not pass the fold rollers.