© Ernst Nagel GmbH 9965043 Operations manual Foldnak 80-100 Trimmer 100.doc Rev.1.3 23.10.2006 14
Different stapling heads
The stapling heads (except ISP) can be put in in any position. But they can cause problems in the area of the
folding knife finger. That is in the range between 94 to 110 mm and 244 to 260 mm.
Please read the manufacturers handbook carefully. You get hints on feeding the stitch wire into the head,
preventive maintenance and repair. In the case of a malfunction, please call your Nagel dealer.
For small formats
: remove leaf springs! Below a width of 152 mm with a stapling head distance of 75 mm.
Hohner
Please use wire #25, order no. 6170110.
Stapling head:
order no. 2660223.
The clinchers (lower arrow) can be adjusted with the alignment tool (upper arrow) to the stapling heads. For
this purpose turn the leaf spring sideways (left photo), take out the former and insert the alignment tool. Now
you can move the clincher sideways, until the marking in the middle aligns with the nose.
The stapling head can be
aligned through lowering
. The machine must be switched off. Disconnect
manually the stapling head clutch. For this purpose open the little lid and push at the place which is marked
with arrow 1 in the picture below. Put an Allen key 4 mm as shown with arrow 2 into the motor shaft and turn
the hexagon socket screw clockwise (arrow 3). After the adjustment turn it further until the stapling head
clutch opens again. The stapling heads are now at the top dead center.
2
3
1
Содержание Foldnak 100
Страница 1: ...Foldnak 80 100 Trimmer 100 Operations manual Service instruction ENGLISH ...
Страница 31: ... Ernst Nagel GmbH 9965043 Operations manual Foldnak 80 100 Trimmer 100 doc Rev 1 3 23 10 2006 31 ...
Страница 32: ... Ernst Nagel GmbH 9965043 Operations manual Foldnak 80 100 Trimmer 100 doc Rev 1 3 23 10 2006 32 ...
Страница 33: ... Ernst Nagel GmbH 9965043 Operations manual Foldnak 80 100 Trimmer 100 doc Rev 1 3 23 10 2006 33 ...
