WHAT’S IN THE BOX
Packed with your VISO TWO you will find
•
An AM loop antenna.
•
A FM ribbon-wire antenna with balun.
•
A removable AC cable (if you wish, any IEC-standard AC cable of suitable
wattage may be substituted).
•
The HTR 6 remote control with 4 (four) AAA batteries.
•
This owner’s manual.
Save the packaging
Please save the box and all of the packaging in which your VISO TWO
arrived. Should you move or otherwise need to transport your VISO TWO,
this is by far the safest container in which to do so. We’ve seen too many
otherwise perfect components damaged in transit for lack of a proper
shipping carton, so please: Save that box!
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to
both sides and behind), and that will provide a clear line of sight, within
23 feet/7 meters, between the VISO TWO’s front panel and your primary
listening/viewing position—this will ensure reliable infrared remote control
communications. The VISO TWO generates a modest amount of heat, but
nothing that should trouble adjacent components.
It is especially important that sufficient ventilation be provided. If you
are contemplating on locating the VISO TWO within a cabinet or other
furniture, consult your NAD audio/video specialist for advice on providing
adequate airflow.
QUICK START
In case you simply cannot wait to experience the performance of your
new NAD VISO TWO, we provide the following “Quick Start” instructions to
get you underway. Before the steps below, connect your VISO TWO to a
TV/monitor.
Please make all the connections to your VISO TWO with the unit unplugged.
It is also advisable to power-down or unplug all associated components
while making or breaking any signal or AC power connections.
plaY a cd or dvd movie
•
Connect the VISO TWO’s composite Video or S-Video “MONITOR OUT”
jack to your TV/monitor’s corresponding input.
•
Connect your speakers to the VISO TWO’s “L” and “R” terminals. Make
sure to connect red to red (“+”) and black to black (“-”) with care to
avoid stray wires or strands crossing between terminals. If your system
includes a powered subwoofer, connect the VISO TWO’s “SUBWOOFER
PRE-OUT” jack to its line input.
•
Connect the AC cord to the AC inlet and then plug into an AC outlet;
the LED indicator around the POWER button will be illuminated amber
indicating the VISO TWO is in standby mode ready to accept commands
from either the front panel power switch or the HTR 6 remote.
•
Press “DVD” at the HTR 6 remote’s Device Selector section and then
“OPEN/CLOSE” button.
•
Insert the media and press [ PLAY] button to start playback.
You should hear sound from VISO TWO, and see an image on the
TV/monitor. (If one or the other fails to appear, check your TV/monitor’s
input settings or VISO TWO’s audio/video connections).
Enjoy the movie or music, but be sure to set aside time to read this manual
thoroughly, and to set up, calibrate, and configure your VISO TWO carefully
and completely.
INTRODUCTION
getting Started
7
EN
G
LI
SH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
