N.KO UZ 15 Rapid, Инструкция по эксплуатации и техническому обслуживанию

Страница: 27 / 43

27
Fig. 6.4.1
TIP:
You can grind the tool for maximum utilization. Do so on a magnetic flat-grinding machine,
from the tool face until the galled, blunt edges are sharp again.
A blunt tool can be recognized visually. Its edges are galled, rounded. Now it is time to grind
it.
If you continue working with a blunt tool, the blunt teeth may crack deep into the tool.
Then, a tool damaged in this way must be ground until the cracked teeth disappear. Thus, you
of course lose many precious meters of potential bevel.
The grinding allowance is approx. 5 mm.
For correct functioning of the machine, it is advisable to pad out the ground tool by the height
ground off. For that, use the original 0.5/1/2 mm pads, or a combination.
Set of compensating washers (0,5 / 1 / 2mm) order.nr. 2140.