N.KO UZ 15 Rapid, Инструкция по эксплуатации и техническому обслуживанию

Страница: 15 / 43

15
Description of control elements
The bevelling machine is operated by means of control devices located on the distributing
box.
A) Green switch:
The green switch starts machine. KEEP IN MIND the tool rotation direction.
Only the clockwise direction is intended for work.
B) Red button:
Push this button to cut off the power supply.
C) Emergency switch
Red mushroom button on a yellow background. Pushing it stops the machine immediately,
overriding any other commands.
Preliminary settings
Attention:
During setting, use working gloves. The operations must be done on a stopped machine,
disconnected from the power supply.
Before starting work, you must execute some settings according to the material thickness and
bevel angle.
Setting the bevel angle
The bevel angle can be set from 15° to 50°.Perform the setting as follows:
- Loose sufficiently the 3 and 3 screws (position A, Fig. 5.3.1) located on both sides of
the machine.
- Grasp the upper handle and pull it to set the entire cutting unit to the required angle.
- You can view the set angle value on the graduated scale located on the side of the
machine (position B, Fig. 5.3.1).
- To complete the operation, fully tighten the 3 and 3 side screws (position A,
Fig. 5.3.1).
Important:
If you have problems setting the angle, the screws may not be loose enough (position A,
Fig. 5.3.1).