Mytrex MXD3G, Руководство пользователя

Страница: 18 / 21

Mytrex MXD3G User’s Manual
Rev 0 July 29, 2013
Page 18 of 21
Spoken Message Meaning Suggested Action
Insufficient cell
service The cell signal is too weak to provide
a reliable connection to the network Verify that the antenna is screwed
tightly to the base unit. Re-position
the unit in the home to obtain a
better cell signal. If these steps do
not correct the problem, verify that
sufficient AT&T cellular 3G service
coverage is available at the
residence.
Monitor Mode The unit is in a special mode that
allows a technician or attendant to
listen to the signals transmitted to
the network and response center The response center attendant may
ask the user to place the unit in this
mode. Please follow the attendant’s
instructions if this is the case.
No cell module The MXD3G cannot detect the cell
phone module The unit needs service. Contact your
provider for a replacement unit.
Please check power
connection The base unit is unplugged from the
wall or the AC power circuit is not
energized Verify the power block is plugged
into a live AC outlet that is not
controlled by a light switch
Please Service Unit The MXD3G has been disabled by
the response center or has
malfunctioned Contact your service provider for
further instructions
Program Medication
Dispenser The unit is ready to be programmed
to accept signals from a medication
dispenser Follow the instructions as directed
on Page 14
Programming mode The unit is in an advanced mode for
programming For provider use only. Press the
RESET button to return the unit to
normal operation.
Program CO Detector The unit is ready to be programmed
to accept signals from a carbon
monoxide detector No carbon monoxide detectors are
currently available for programming
to the MXD3G
Program Personal
Help Button Group
___ The unit is ready to learn a PHB code
into a PHB group other than Group 1 Program the PHB into the group as
directed on Page
13
Program Personal
Help Buttons The T/L button has been pressed
once, followed by the base unit HELP
button one time. The unit is now
ready to be programmed to
recognize a new Personal Help
Button Program the new PHB codes into the
base unit per the instructions
starting on page
12 .
Program Smoke
Detector The unit is ready to learn the code
for a smoke detector No smoke detectors are currently
available for programming to the
MXD3G
Program Supervised
Device The unit is ready to learn the code
for a supervised device Program the new supervised device
into the base unit as instructed on
page
15 .