Mytrex MXD3G User’s Manual
Rev 0 July 29, 2013
Page 14 of 21
3.
Press and release the base unit HELP button a second time. The base unit will announce,
“Program Personal Help Buttons Group Two.”
4.
Program PHB codes into Group 2 by following steps 3 through 6 in the instructions for
programming PHBs into Group 1.
5.
If PHB codes are to be programmed into Group 3, press the HELP button again. The base unit
will announce,
“Program Personal Help Buttons Group Three.”
6.
Program PHB codes into Group 3 by following steps 3 through 6 in the instructions for
programming PHBs into Group 1.
7.
If PHB codes are to be programmed into Group 4, press the HELP button again. The base unit
will announce,
“Program Personal Help Buttons Group Four.”
8.
Program PHB codes into Group 4 by following steps 3 through 6 in the instructions for
programming PHBs into Group 1.
9.
After all PHBs are programmed into the desired groups, press the RESET button one time. The
MXD3G will announce, “
[number] Bars, System Ready.”
This completes the programming
sequence, and each of the PHBs recorded in Group 1 should now be recognized by the unit.
10.
Test all of the PHBs ONE AT A TIME by pressing each button and allowing the unit to call the
response center. Wait to start the next PHB test until the unit has disconnected from the
previous test call. Check carefully with the response center attendant to verify that each PHB
has been programmed into the correct PHB group.
11.
If each test call is successful, the PHB is ready for service. Reprogram any PHBs into the desired
group that do not activate the base station when pushed.
Programming Medication Dispensers
Note: Medication dispensers may not be supported by your service provider. Contact your service
provider to determine if this option is available.
To program a Medication Dispenser Code into the MXD:
The MXD3G unit can be programmed to
recognize up to two Mytrex approved medication dispensers that have been equipped for monitoring
with the MXD3G.
Preparing the Medication Dispenser: Perform the following steps for each medication dispenser that
the MXD3G will be programmed to recognize:
1.
Connect the medication dispenser to its power cord and plug the power block into the wall.
2.
Make sure that the medication dispenser is turned on
3.
Unlock and remove the medication dispenser’s top cover
4.
Remove the medication dispenser’s circular pill tray from the dispenser.
5.
Locate the transmitter circuit board underneath the circular pill tray, between the dispenser
center mechanism cover and the outer wall of the dispenser case.
6.
Locate the small test button on the transmitter circuit board. It is a silver round button
approximately 3/16 inches in diameter.
