Mytee 8070 Lite, Руководство пользователя

Страница: 11 / 16

11
2 - Machine Operation
3. Once pump is primed and there is pressure in the solu-
tion line, turn on heater switch and wait a few minutes for
water to heat up.
4. Once water is heated, turn on vacuum and begin clean-
ing.
Note: When cleaning upholstery, always check manufac-
turer’s cleaning instructions.
Cleaning Procedure
For best results when extracting, do one wet pass
followed by two dry passes. This ensures you’re not
over-soaking the material and keeps water temperature
higher.
The solution pump will only turn on when there is a pres-
sure demand (e.g., while spraying with cleaning tool, or
right at startup). If the pump is continuously running or
pulsing, there may be an issue with the pump pressure
switch. See the Troubleshooting section of this manual.
♦
2.5 - Emptying the Solution & Recovery Tanks
The solution tank drain is located on the front, lower left
corner of the solution tank.
The recovery tank drain is located on the back of the
machine at the bottom of the recovery tank. Attach the
included recovery tank drain hose in order to easily emp-
ty into a bucket or other receptacle.
♦
Use only low foam or non foaming detergent
or shampoo. Damage due to excessive foam
will void warranty.
Empty the vacuum tank any time you refill
the solution tank in order to prevent vacuum
tank overfilling.