8
NOTE: Test water temperature by turning the flow control lever clockwise. Allow the water
to stabilise, this should be at approximately 38˚C. Use a thermometer to accurately
measure this temperature.
WALL ARM FITTING FOR Atmos Zinc/Zone
1.
Establish position of wall arm to suit users requirements (See Fig 20).
2.
When fitting the wall arm drill a suitable 19mm hole through the wall.
NOTE: When fitting to stud wall a bearer between the uprights maybe required.
3.
Remove fittings and nuts from end of arm and push arm through wall, re-fit washer
and nut.
4.
Connect mixed water outlet using compression and fittings.
5.
When attaching a fixed overhead make sure the sealing washer is in place and
screw tight to seal the joint (See Fig 21).
Flow
Control
Knob
Large Spline
Trimplate
Spline
Trimplate
Stop Ring
Spline
Trimplate
Temperature
Control Knob
Stop Ring
19
17
18
21
20
