MV Agusta BRUTALE 910 S, Руководство по ремонту

Страница: 35 / 112

Engine
- 19 -
B
The attainment of the correct CO value could involve a
variation of the engine speed at minimum.
In this case you should operate the by-pass screws
again to return the speed to the desired value and then
repeat the trimmer adjustment.
After having finished the adjustment operations,
perform in the order as follows:
- assemble the rubber plug on the gearcase lower side;
- apply a new seal plate;
- assemble the gearcase on the air filter compartment
restoring the earth bonding;
- disassemble the exhaust gas probes and tighten the
fixing screws;
- restore the sealing caps of drives for checking
depression;
- reassemble tank, tank side panels, ignition switch
cover, rider seat and passenger seat.
After reassembling all parts, carry out a final check to
ensure that everything has been correctly replaced.