MV Agusta BRUTALE 910 S, Руководство по ремонту

Страница: 108 / 112

- 92 -
Engine
B
2 mm
Place the clamp lock at a range of
2 mm
from the
screwhead on the supporting plate of oil cooler pipes.
Tighten the screw of the clamp until it comes into con-
tact with the filter, without tightening.
Mark the screw position drawing a line by a felt-tip both
on the screw and on the clamp.
Make the last tightening of the screw getting it perform
2 turns and 1/4 further the position marked previously.
-1÷1,5 mm
Once completed the assembly, ensure that the clamp
lock of the engine oil filter is at a range between
1
and
1.5 mm
from the screwhead on the supporting plate of
oil cooler pipes. Check any leakages from oil filter.
Mark the position of the definite tightening of the screw
using a felt pen, both on the filter and the band faste-
ner. Trace a reference mark also on the band fastener
and the relative screw, with the object of eventually
checking any slackening of the screw.
Do not use the oil filter as a point of grip or
contact.