HDMI 4x4 Matrix Switch Kit, HDBT, PoC, 4K/60
Installation & Operation Manual
© MuxLab Inc. 2017
14
c)
Connect up to three (3) HDBT Receiver(s) to the HDBT Link output port(s) of the
HDMI 4x4 Matrix Switch, with a UTP Cable.
d)
An AVR amplifier with a TOSLink Optical Cable may be connected using the
SPDIF output port.
e)
Self-powered speakers may be connected to RCA Jacks (L&R) output port using
an audio cable.
f)
Connect the controlling device (e.g. PC) to the
RS232 Input
port of the HDMI
4x4 Matrix Switch, with the supplied RS232 cable.
g)
Connect a Patch cord from the router to the Ethernet port on Matrix Switch to
control the Matrix Switch using TCP/IP protocol or a WEB GUI.
h)
Connect an IR Sensor to the
IR Sensor
port, and an IR Emitter to the
IR Emitter
port. The IR signal can be transmitted bi-directionally between the HDMI 4x4
Matrix Switch and the HDBT Receiver(s).
i)
Connect the included DC 24V power adapter to the power port of the 500412.
Note:
1. Connect the HDBT ports of the Matrix Switch and far-end HDBT Receiver with
straight-through cable.
2. IR Sensors connected to the IR Sensor Inputs should support a carrier-wave signal.
If the IR sensor does support carrier-wave then, send the command
“%0900.” to
activate native carrier mode. However, if the IR sensor does not support
carrier-
wave, then send the command “%0901.” to activate and force the IR Matrix
to send a carrier-wave signal to the far-end HDBT Receiver.
4.4. Connection with the HDBT Receiver
The Matrix Switch has 3 HDBT outputs which support PoC technology. Connect a Cat
5e/6 patch cord to the HDBT Outputs and connect it to the pre-installed infrastructure.
Connect HDBT Receivers to the pre-installed cabling via additional patch leads. Plug
the power supply in to the power socket on the matrix, the HDBT Receivers will be
powered by the 500412 Matrix Switch.
