HDMI 4x4 Matrix Switch Kit, HDBT, PoC, 4K/60
Installation & Operation Manual
© MuxLab Inc. 2017
16
System Operations
5.
5.1. Front Panel Button Control
The HDMI 4x4 Matrix Switch can be controlled via the front panel. Please follow the
basic programing instructions below:
1. To connect one input to an output:
Example: Input 1 to Output 3
→ Press the Output 3 button until the Input 1 LED is ON
NOTE:
Default status, on first boot up this matrix assigns the IR outputs to the
corresponding HDMI input, meaning, IR out 1 is directly associated to HDMI
input 1 and so on. When you switch an HDMI input to a different output, the
corresponding IR OUT will be switched synchronously to allow the IR
commands to be sent from the select zone back through the Matrix Switch to
the source.
2. To connect one input to several outputs:
Example: Connect Input 2 to Output 3 and 4
→ Press the Output 3 button until the Input 2 LED is ON
→ Press the Output 4 button until the Input 2 LED is ON
3. To connect an input to all the outputs:
Example: Input 1 to all Outputs
→ Press the Output 1 button until the Input 1 LED is ON
→ Press the Output 2 button until the Input 1 LED is ON
→ Press the Output 3 button until the Input 1 LED is ON
→ Press the Output 4 button until the Input 1 LED is ON
Note:
LED
Indicators of the pressed buttons above will blink green for three times if the
connections were completed successfully, then the LED will switch OFF. If the
connection failed, they the LEDs will turn OFF immediately.
