WARNING
THE MSD901 SHOULD BE WORN WITH ALL THREE MODULES ASSEMBLED. THE MODULES
ARE NOT DESIGNED TO BE WORN INDEPENDENTLY, AND A LOSS OF PROTECTION AND
WEAR RESISTANCE WILL RESULT IF WORN IMPROPERLY.
Assembly
MSD901 Assembly Steps
STEP
1 Lay out the thermal liner and immersion module
a) Lay out the thermal liner and the immersion module side by side in the same
orientation as if you were going to wear them.
Note:
Check the labels of the thermal liner to ensure that they are
located on the inside (the seams of the thermal liner should face out).
b) Make certain the neck seal adjustment on the immersion module is fully open
and facing up. Make sure the waterproof zipper is fully opened.
1
Thermal
Liner
Immersion
Module
FIGURE 3
MSD901 Industrial
Immersion Work Suit Layers
