Munters HCUw, Эксплуатация и техническое обслуживание

Страница: 100 / 122

70
3 G 3 J V L i s t o f P a r a m e t e r s
Chapter 9
Pa- Name Description Set- Unit Default Changes Ref-
ram- ting of set- setting during er-
eter range ting opera- ence
No. tion page
n39 Multi-func- 12 External ON: Output shut off (while 2 to 8, 1 6 No 5-18
tion input 4 base block motor coasting to a stop 10 to
(Input termi- command and "bb" flashing) 22, 34
nal S5)) (NO)
13 External OFF: Output shut off (with
base block
command
(NC)
motor free running and "bb"
flashing)
14 Search com- ON: Speed search
mand
(Searching
starts from
maximum
frequency)
(Searching starts from n09)
15 Search com- ON: Speed search
mand
(Searching
starts from
preset fre-
quency)
16 Acceleration/ ON: Acceleration/Decelera-
Decelera-
tion-prohibit
command
tion is on hold (running at
parameter frequency)
17 Local or re- ON: Local mode (operated
mote selec-
tion
with the Digital Operator)
19 Emergency The Inverter stops accord-
stop fault
(NO)
ing to the setting in n04 for
interruption mode selection
with the emergency stop in-
20 Emergency put turned ON.
stop alarm
(NO)
NO: Emergency stop with
the contact closed.
NC: Emergeenc.y stop with
21 Emergency the contact opened.
stop fault
(NC)
Fault: Fault output is ON
and reset with RESET
input. Alarm output is ON
22 Emergency (no reset required).
stop alarm
(NC)
"STEP" is displayed (lit
with
fault input ON and flashes
34 Up or down Up or down command (set
command in n39 only)
By setting n39 to 34, the
set value in n38 is ignored
and the following setting
are forcibly made.
S4: Up command
S5: Down command