Munters HCUw, Эксплуатация и техническое обслуживание

Страница: 101 / 122

71
3 G 3 J V L i s t o f P a r a m e t e r s
Chapter 9
Pa- Name Description Set- Unit Default Changes Ref-
ram- ting of set- setting during er-
eter range ting opera- ence
No. tion page
n40 Multi-func- Used to select the functions of multi-function output 0 to 7, 1 1 No 5-21
tionn output terminals. 1 0 to
( MA / MA )
a out- Set
value
Function Description 1 7
put termi-
nals)
0 Fault output ON: Fault output (with pro-
tective function working)
1 Operation in ON: Operation in progress
progress
2 Frequency ON: Frequency detection
detection (with frequency reference
coinciding with output fre-
quency)
3 Idling ON: Idling (at less than
min. output frequency)
4 Frequency ON: Output frequency >
detection 1 frequency detection level
(n58)
5 Frequency ON: Output frequency <
detection 2 frequency detection level
(n58)
6 Overtorque Output if any of the follow-
being moni-
tored (NO-
contact out-
put)
ing parameter conditions is
satisfied.
n59: Overtorque detection
function selection
n60: Overtorque detection
level
7 Overture be-
ing moni-
tored (NC-
contact out-
put)
n61: Overtorque detection
time
NO contact: ON with
overtorque being detected
NC contact: OFF with
overtorque being detected
8 Not used ---
9
10 Alarm output ON: Alarm being detected
(Nonfatal error being de-
tected)
11 Base block Base block in progress (in
in progress operation with output shut-
off)
12 RUN mode ON: Local mode (with the
Digital Operator)
13 Inverter ON: Inverter ready to oper-
ready ate (with no fault detected)
14 Fault retry ON: Fault retry
15 UV in prog- ON: Undervoltage being
ress monitored
16 Rotating in ON: Rotating in reverse
reverse
direction
direction
17 Speed ON: Speed search in prog-
search in
progress
ress