Munters comdry m170l, Руководство пользователя

Страница: 18 / 48

ComDry M160L
6.3 Initiation and start
6.3.1 Boot the control system
Connect the dehumidifier to mains. Result: The control system will initiate by flashing all LEDs for a few
seconds, and the display first shows the ComDry machine type
[
[M160L
]
, then the set frequency, e. g. [50Hz]
and finally the software version number, e. g. [VER: 1.00] and the current humidity level, e. g. [*RH1 46%].
NOTE!
The boot sequence takes about 10 seconds. Let the control system finish the booting before attempting
to start the dehumidifier.
6.3.2 Start the dehumidifier
Follow these steps to start the dehumidifier:
Step Action Illustration
1 Press the On/Off button (C) once to start the dehumidifier.
Result: If the measured humidity is lower than the Set Value,
the green operating indicator (B) will start to flash in a long
on/short off sequence. Depending on fan mode setting, the
process fan will run or not. The unit is now in stand-by mode.
C
B
2 The dehumidifier starts to dehumidify when the measured
humidity is equal or greater than the Set Value, and the
operating indicator (B) will shift to continuously lit.
B
15
Operation
190TEN-1098-D1404