Munters comdry m170l, Руководство пользователя

Страница: 11 / 48

ComDry M160L
4.5 Installation of the unit
ComDry M160L is designed to be mounted on a wall using the wall bracket included in the delivery of the
unit. See the separate wall bracket leaflet.
1. Assemble the three main parts of the wall bracket. See item 1,2 and 3 in the leaflet. Use the four screws
included.
2. Mark four wall holes using the enclosed drill pattern. Make sure to get at least 25 cm space between the
dehumidifier and the floor.
3. Use four screws with a maximum diameter of 7 mm (not included) to mount the bracket on the wall.
4. Screw the wall bracket on to the wall.
5. Lay down the dehumidifier.
1
2
Figure 4.3 Figure 4.4
6. Insert the O-ring (1) in to the drain pipe sleeve (2). Press the O-ring so it is properly seated in the groove
see Figure 4.3
7. Push the drain pipe on to the drain connection of the tray, see Figure 4.4
8. Fasten the drain pipe with the two enclosed screws.
9. There are two slots in the shelf enabling a lashing strap to be mounted if the dehumidifier is to be fixed
by a strap.
10. Alternatively the four feet can be locked simply by changing the screw in each foot to a longer (not
included) and use the four pre-drilled holes in the bracket. Four new washers will also be needed.
11. Finally put the hose on to the drain pipe and lock the hose using a hose clamp.
12. If ducts or hoses are to be installed , see section
4.6, Ducts and hoses .
190TEN-1098-D1404
Installation
8