
Hand Extruder MEK-32 / MAK-32
Page 14/20
Issue 12.2009/Rev. 02
MUNSCH Kunststoff-Schweißtechnik GmbH
6 Maintenance/Inspection
Pull mains connector before carrying out any
maintenance and repair work on the hand extruder.
Maintenance and repair work on electrical tools may
only be carried out by qualified electricians.
The hand extruder together with the hot air
hood must have cooled down to safe-to-touch
temperature.
Observe the instructions under section “Safety“.
Maintenance and repair work may only be carried
out by qualified personnel or by our service staff.
To ensure the proper function of the hand extruder
over its entire service life for its intended service, we
recommend:
-
to have all maintenance, inspection and mounting
work carried out by authorized and qualified
personnel who are familiar with the operating
instructions,
-
to always shut off the unit before carrying out any
work on it,
-
to remount and reactivate all safety and
protective devices immediately after completion
of the maintenance/repair work.
During maintenance and repair work, make sure that
the hand extruder and its individual components are
firmly positioned.
In addition to the operating instructions and the
national and local accident prevention regulations
applicable at the place of use, the acknowledged
technical rules for safe and proper working practices
must be observed.
Any working practices posing a safety risk are
prohibited.
Activities other than those described in this
section may only be performed at the Manufacturer’s
workshops!
6.1 Maintenance/inspection of MEK/MAK hand
extruder
•
CAUTION After approx. 500 operating hours, the
hand extruder including drive unit must be
thoroughly cleaned and inspected. This work may
only be carried out at the manufacturer’s
workshops.
•
CAUTION Cables, switches, plug-in connections
must be inspected by qualified staff every three
months (requirement according to VBG4); the
inspection results must be documented!
6.2 Dismantling
Prior to dismantling the hand extruder, pull the mains
connector.
The hand extruder must be at ambient temperature.
Damaged mains connection cables must be
completely replaced. “Mended” cables pose a hazard
to life and limb. Cable replacement is to be carried
out by qualified electricians only.
The safety precautions described under sections
“Safety“ and “Malfunctions, Causes and Remedies“
must be strictly adhered to.
6.2.1 Overview of spare parts/attachments
When ordering spare parts, always indicate the
serial number of the extruder.
Make sure to use original spare parts only.
For spare parts supply, contact MUNSCH Kunststoff-
Schweißtechnik GmbH.
Drive unit UX1 – Replace carbon brushes:
Remove the 3 screws and pull off the cap. Remove
dirt / carbon dust using compressed air, for instance.
Replace carbon brushes (2 x K04886) and screw the
cap in place again.
----------------------------------------------------------------------
Extruder screw bearing:
K03701 = Axial bearing (replace)
K03702 = Ball bearing (replace)
K03703 = Circlip (replace, if necessary)
K03704 = Seal ring (replace)
K04080 = Spacer ring (replace, if necessary)
----------------------------------------------------------------------
Содержание MAK-32
Страница 13: ...MEK 32 MAK 32 Issue 12 2009 Rev 02 Page 13 20...
Страница 15: ...MEK 32 MAK 32 Issue 12 2009 Rev 02 Page 15 20...