14
▪
Loosen all Conveyor Mount Bracket M8 Button Head Bolts
do not remove
without moving the
conveyor from its left to right position wiggle the conveyor slightly. And retighten all eight
Conveyor Mount Bracket M8 Button Head Bolts to 4.5 ft-lb (6 Nm).
▪
Repeat as necessary until the conveyor moves smoothly from horizontal to pivoted without
binding.
13.
Pivot conveyor back to operating position and tighten Pivot Bracket Thumb Screws.
Installing the Drive Assembly
Parts Needed:
Drive / Drive Mount Bracket
Drive installation fasteners:
M8 Button Head (2)
Drive Mount Spacer 60mm
1.
Locate the Drive Mount Bracket mounting notch on the
operator side of the Shield Assembly, position the 60mm
M8 Drive Mount T Nut, pre-installed within the Conveyor
Frame Channel, in the center of this slot.
▪
If the 60mm M8 Drive Mount T Nut has shifted
position it may be necessary to lift the Shield
Assembly to slide this T Nut into position. If Shield
is loosened, ensure thumb screws are tight before
continuing.
2.
Remove the Motor and Drive Assembly from the box, set the Motor on the ground below the conveyor
in the center of the machine.
3.
The Drive will have the Drive Mounting Bracket pre-installed.
Using the two M8 Button Head Bolts, and 60mm Drive
Mount Spacer mount the Drive Assembly to the Conveyor
Frame. The Drive Mount Spacer should be located between
the Drive Mount Bracket and the Conveyor Frame, the M8
Button Head Bolts will pass through both the bracket and
Spacer to thread into the 60mm M8 Drive Mount T Nut.
Center the Drive Mount Bracket within the Shield notch and
tighten M8 Button Head Bolts to 4.5ft-lb (6 Nm).
