Multitone RPR 563, Инструкция по изменению

Страница: 32 / 116

RPR 563
TM1195 Issue 1 Page 2 - 14
ABSENCE RACK REGISTRATION AND CHARGING
51. The transceiver contains a rack message which may be up to a maximum of nine
characters in length. The factory programmed default rack message "Absent" may be
changed by using Programming Unit P648 and programming software P648T, together
with an IBM PC or compatible personal computer.
52. Insert the transceiver into a pocket within the rack. The transceiver's LED illuminates
at half brightness when charging commences and the following rack message appears
on the display when the transceiver recognises absence mode.
Absent or PROGRAMMED MESSAGE
53. The transceiver is interrogated by the system and if a user number is associated with
the transceiver address the user number is displayed as follows:
Absent 1234 or PROGRAMMED MESSAGE 1234
54. If the interrogation is unsuccessful there are two possibilities:
a) If there is no contact between paging system and transceiver, the following display
is shown:
Absent or PROGRAMMED MESSAGE
b) If there is no user number associated with the transceiver address the following
display is shown:
Absent ---- or PROGRAMMED MESSAGE ----
55. If the transceiver is switched off when inserted into the rack with a serviceable battery
unit, the charge lamp will light but no absence registration will take place. If the battery
unit is flat when inserted in the rack, the transceiver will switch on, the charge lamp
illuminates and registers absent as normal.
56. If the transceiver is placed in the absence rack with a totally-discharged battery pack,
one of the following situations will arise:
a) the charge LED will light, the absent or programmed message will be displayed.
b) the charge LED will light, flashing `E's will be displayed.
c) the charge LED will light, the transceiver will switch on and start its initialisation
routine.