Multitech MultiModem MT5600ZDXV, Руководство пользователя

Страница: 36 / 65

36
Model MT5600ZDXV
X2 Sends X1 messages with NO DIALTONE.
X3 Sends X1 messages with BUSY.
X4 Sends all responses.
*
If the modem is in facsimile mode (e.g., +FCLASS=1), the only message
sent to indicate a connection is CONNECT without a speed indication.
Command: Y
n
Long Space Disconnect
Values: n = 0
Default: 0
Description: Y0 Disable sending or responding to long space break
signal on disconnect.
Y1 Enables long space disconnect. In non-error correction
mode, the modem will send a long space of four
seconds prior to going on-hook. In non-error correc-
tion mode, the modem will respond to the receipt of a
long space (i.e., a break signal greater than 1.6
seconds) by going on-hook.
Command: Z
n
Modem Reset
Values: n = 0 or 1
Default: None
Description: Z0 Reset modem to profile saved by the last &W command
(profile 0).
Z1 Reset and restore stored profile 1.
Command: &C n Data Carrier Detect (DCD) Control
Values: n = 0 or 1
Default: 1
Description: &C0 Ignores the state of carrier on the remote modem and
DCD circuit is always on.
&C1 DCD turns on when the remote modem’s carrier signal
is detected and DCD is off when the carrier signal is not
detected.
Command: &D n Data Terminal Ready (DTR) Control
Values: n = 0, 1, 2, or 3
Default: 2
Description: &D0 Modem ignores the true status of the DTR signal and
responds as if it is always on.
&D1 When DTR drops while in online data mode, the
modem enters command mode, issues an OK, and
remains connected.