PAGE 28 — PRO SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (9/21/17)
Weight Installation (Optional)
Refer to Figure 25.
Figure 25. Weight Installation
1. Open the locking pin.
2. Place the weight(s) onto the weight posts and insert
the locking pin into the weight post hole nearest the
weight(s).
3. Close the locking pin.
4. A properly installed weight is shown in Figure 25
A.
Fresno Brush Weight Installation (Optional)
Refer to Figure 26.
NOTICE
The four weights are an optional feature. The use
of the weights is determined by the operator. It is
recommended to install equal weights on both sides
of the weight posts.
A
LOCKING PIN
WEIGHT
POST
WEIGHT POST
HOLE
NOTICE
The six fresno brush weights are an optional
feature.
The use of the weights is determined by the operator.
It is recommended that the weights be equal on both
sides of the brush.
Figure 26. Fresno Brush Weight Installation
1. Slide the 1/4-20 × 1-1/4" screw into the brush channel.
2. Place the three brush weights onto the 1/4-20 × 1-1/4"
screw.
3. Place the 1/4" flat washer and 1/4-20 nyloc nut onto
the screw.
4. Using a 7/16" wrench, tighten the 1/4-20 nyloc nut
securely.
5. Repeat on the opposite side.
NOTES:
1
FRESNO BRUSH WEIGHT
KIT INSTALLATION IS
IDENTICAL FOR BOTH SIDES.
1
1
1/4-20
NYLOC NUT
CHANNEL
FRESNO
BRUSH
WEIGHTS
1/4-20 × 1-1/4"
SCREW
SET-UP
