MULTIQUIP GloBug GB4000, Руководство по эксплуатации и запасным частям

Страница: 8 / 42

PAGE 8 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL —REV. #1 (02/25/14)
LIGHTTOWER SAFETY
DANGER

NEVER operatetheequipmentinanexplosive
atmosphereornearcombustiblematerials.An
explosion or fire could result causing severe
bodily harmor evendeath.
WARNING

NEVER disconnect any emergencyor safetydevices.
These devices are intended for operator safety.
Disconnectionof thesedevicescancausesevereinjury,
bodilyharmor evendeath.Disconnectionof anyof these
devices will void all warranties.

NEVER lubricate components or attempt service on a
running machine.

ALWAYS ensure light tower is on level ground before use
sothat itcannot slideorshift around, endangeringworkers.
Always keep immediate area free of bystanders.

ALWAYS make sure trailer is leveled with all outriggers
extended before raising tower. Outriggers must remain
extended while tower is up.

ALWAYS keep area behind trailer clear of people while
raising and lowering mast.

NEVER remove safetypin or pull mast locking pin while
tower is in a raised position!

CHECK the mast and winch cables for wear. If any
problemoccurswhenloweringor raisingthetower, STOP
immediately! Contact atrainedtechnicianfor assistance.

NEVER pivot or retract mast while unit is operating.

NEVER use the light tower mast as a crane. DO NOT
lift anything with the mast.

ALWAYS lower thelight tower whennot inuse, or if high
winds or electrical storms are expected.
SAFETY INFORMATION

ALWAYS keep the immediate area surrounding the light
tower clean, neat, and free of debris.

ALWAYS keep the machine in proper running condition.

Fix damage to machine and replace any broken parts
immediately.

ALWAYS store equipment properly when it is not being
used.Equipment shouldbestoredinaclean, drylocation
out of the reach of children and unauthorized personnel.

Toprevent thelight tower fromoverturning, NEVER use
in winds that exceed 65 MPH ( 105 km/h ).
LAMP SAFETY

NEVER attempt to replace lamp with the power on.
Alwaysshut downtheengineandturnoff circuit breakers
when changing the lamp.

ALWAYS allow a sufficient amount of time for the lamp to
cool before touching or changing. The possibility exists of
severeburns.

NEVER useforcewheninstallingthelamp.Excessiveforce
could cause the lamp to break, causing bodily harm.

NEVER leaveany greaseor oil residueonlampsurface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.

ALWAYS make sure lamp surface is clean and dry.

ALWAYS replace with MQrecommended type lamp.

ALWAYS havea trainedtechnician install andremove
a floodlight, or replace any damaged fixture wiring.
NOTICE
CAUTION
WARNING
NOTICE
CAUTION