MULTIQUIP GloBug GB4000, Руководство по эксплуатации и запасным частям

Страница: 24 / 42

PAGE 24 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL —REV. #1 (02/25/14)
REMOVINGBALLOON PROTECTIVE COVER
OPERATION
4. Once, the engine has started, place the main circuit
breaker switch (Figure 12) on the LT12 control panel
in the ON position.
LT12
LIGHT TOWER
240 VAC/30A 120 VAC/15A
MAIN
BREAKER
GFCI
BREAKER
1. Expose the balloon by unsnapping the buttons and
unzipping the protective cover as shown in Figure 11.
MAIN
CIRCUIT
BREAKER
ON
SNAPS
UNZIP
PROTECTIVE
COVER
BALLOON
FULLY
EXPOSED
CB1 CB2 CB3 CB4
FOLD PROTECTIVE
COVER INTO ITSELF
Figure 11. Removing Protective Cover
2. Next, fold the protective cover into itself and zip. See
Figure 11.
INFLATING BALLOON ANDTURNING ON LAMPS
(LT12 ONLY)
1. OnLT12serieslight towers, reconnect negativebattery
cable (black).
2. Slightly raise the light tower mast to allow clearance
for the balloon to inflate.
3. Start the light tower engine as referenced in the LT12
light tower operation manual.
Figure 12. Main Breaker ON (LT12)
5. Next, turnonlampcircuit breakers.Theballoonshould
begin to inflate and the lamps will light.
6. Secure any unused lamp cables.
7. Raisethelight tower mast tothedesiredupright height.
CAUTION
DO NOT use excessive force when
zipping or unzipping the balloon. The
possibility exists of the zipper tearing,
whichwouldmaketheballoonunusable.
LIGHT CONTROL/BREAKER