Multi-Tech MultiModem ISIHI-2S, Руководство пользователя

Страница: 10 / 186

10 MultiModemISI Hybrid Series, ISIHI-2S
Chapter 1– Introduction
Manual Organization
Chapter 1–Introduction
Introduces and describes the ISIHI-2S. It describes features, provides manual
organization, and lists technical specifications.
Chapter 2–Hardware Installation
Describes how to install the ISIHI-2S card into the ISA bus of your personal computer
system and how to configure card settings (I/O address DIP switch setting and jumper
setting). This chapter also provides you with procedures for physically connecting the
ISIHI-2S to the ISDN BRI line.
Chapter 3–Software/Driver Installation
Chapter 3 provides detailed steps to install software/drivers to configure and operate the
ISIHI-2S via its firmware-based ConfigMenu utility or software-based ISDN TA
Configuration Wizard.
Chapter 4–Modem AT Commands, S-Registers, Result Codes
Provides an introduction to the ISIHI-2S’s modems command mode fundamentals
followed by a detailed explanation of each AT command with examples where applicable.
This chapter also describes the modem’s S-registers, which are used to store various
modem options, and result codes that report the results of a command.
Chapter 5–Terminal Adapter AT Commands, S-Registers, Result Codes
Provides an introduction to the ISIHI-2S’s terminal adapters command mode
fundamentals followed by a detailed explanation of each AT command with examples
where applicable. This chapter also describes the TA’s S-registers, which are used to
store various modem options, and result codes that report the results of a command.
Chapter 6–Troubleshooting Guide
If you think your ISIHI-2S is not working correctly, this chapter covers common problems
and how to solve them.
Chapter 7–Service, Warranty, and Technical/BBS
Provides information on the ISIHI-2S warranty, instructions for getting the ISIHI-2S
serviced at the factory, and procedures for firmware upgrades via FlashROM. It also
contains information on Multi-Tech’s Bulletin Board Service (BBS), how to access
technical support via the Internet, and information on Multi-Tech’s Fax-Back Service.
Appendix A–Determining Current System Settings
Appendix B–Base I/O Switch Settings
Appendix C–Pin Assignments
Appendix D–ISIHI-2S Testing Utilities
Appendix E–Configuration Profiles
Appendix F–Ordering ISDN BRI (2B+D) Lines
Appendix G–ASCII Conversion Chart
Appendix –Dial Pulses and Tones
Appendix I–Modem AT Command Summary
Appendix J–Modem S-Register Summary