Multi-Tech MultiModem ISIHI-2S, Руководство пользователя

Страница: 52 / 186

52 MultiModemISI Hybrid Series, ISIHI-2S
Chapter 3—Software/Driver Installation
NetWare Connect (Novell) Driver Installation
Multi-Tech Systems provides AIO drivers for the ISIHI-2S, so it can function with Novell
compatible asynchronous applications (e.g., NetWare Connect). The AIO driver is simply
an NLM (NetWare Loadable Module) that runs on the file server. Drivers must be loaded
on the file server where the board is installed. Drivers can be loaded from the file server’s
console prompt or incorporated for autoloading in the AUTOEXEC.NCF file.
To install the Multi-Tech AIO driver, copy the file AIOISIX.NLM to the system directory of
the file server from a workstation on the network. To copy, use the following command:
COPY A:\AIOISIX.NLM F\:SYSTEM
To load the driver, go to the system or PC console (where the ISIHI-2S is installed) and
enter the following at the prompt:
LOAD AIOISIX [port=W] [int=X] [name=Y] [note=Z]
W is the hexadecimal I/O port address for the ISIHI-2S. The ISIHI-2S occupies the
next 15 I/O addresses on the bus. That is, if you specify the address 210 hex, then
the ISIHI-2S occupies addresses from 210 hex to A hex (total of 16 addresses).
X is the interrupt (IRQ) vector number for the ISIHI-2S. The ISIHI-2S can be set for
IRQ vectors 10, 11, 12 & 15.
Y sets the ISIHI-2S board name.
Z overrides the default node ID number for the ISIHI-2S.
Note: All these parameters are optional. If none are supplied, the AIO driver assumes the
default I/O address and IRQ values and tries to load the driver.
IRQ Jumpers
Setting IRQs consists of installing the IRQ jumper on the two pins that indicate the
interrupt vector. For example, IRQ10 is chosen in the configuration below.
2 3 4 5 7 10 11 12 15
: : : : : [:] : : :
Error Messages
1. *Error: An ISIHI-2S does not seem to appear at address X*
The driver could not find the ISI residing at the address X. Make sure there is no
other device in your system at the same I/O address and that the ISI is seated
properly in the system slot.
2. *Error: ISIHI-2S rejected the load header*
*Error: ISIHI-2S got out of sync*
*Error: ISIHI-2S verify failed at address X*
*Error: Expected X received Y*
*Error: Verify got out of sync*
All the above errors represent problems with the file server not being able to
communicate with the ISIHI-2S. Make sure no other device is residing in the system
at the same I/O address you chose for the ISIHI-2S. Power down the server and
make sure the ISIHI-2S is seated properly in the system slot. Power up the file server
and try to load the AIO driver again. If the problem persists, contact the Multi-Tech
Technical Support team.