tint-STARTER SET
INSTRUCTION MANUAL
67
Reset
Reset to 100% light
The tint light bulbs can be easily reset by light switch to the basic setting
of warm white and 100% brightness. This may be necessary, for example,
if you have dimmed the bulbs before and the remote control‘s batteries are
empty. This feature may also be used in the normal case if you do not have
the tint remote control on hand.
1. Use the light switch to switch the bulb off and on again 3 times.
2. The bulb will now start in its basic setting, warm white, 100%.
Resetting the tint remote control
A reset will only be required in exceptional cases, such as when the bulb no
longer responds to the tint remote control after removing and reinserting
the batteries.
Resetting the remote control will delete all pre-defined group
settings and you will have to connect the tint remote control and
the bulbs again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object or the battery compartment cover to press the
reset button on the back of the remote control.
3. Then, proceed as described in the section “Resetting the tint bulb”
and then as described in the section “Adding a new bulb”. Each bulb
will then have to be connected individually one after the other. If, for
example, three bulbs belong to one group, you must repeat the steps in
“Adding a new bulb” 3 times.
