tint-STARTER SET
INSTRUCTION MANUAL
65
6. If desired, you can select a different group by repeatedly pressing the
group button (middle LED = group 2 etc.).
After approx. 10 seconds, the new bulb will be added to the selected
group and the feedback display will stop blinking. Wait this long, not
pressing any buttons during this time.
The procedure will then end and you can use the extended group as
normal.
Remove a bulb from the tint remote control
1. Switch the bulb off (to standby) with the tint remote control if neces-
sary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The
bulb will signal that it has been selected by increasing and decreasing
its brightness. The bulb will blink in the order in which they are stored
in the tint remote control.
5. Hold down the standby button for approx. 5 seconds. The bulb will
then signal that it has been removed from the tint remote control by
flashing and then dimming.
