tint-STARTER SET
66
INSTRUCTION MANUAL
Shift a bulb from one group into another group
1. Switch the bulb off (to standby) with the tint remote control if neces-
sary.
2. Select the group you would like to change using the group button.
(If you would like to add a bulb from group 2 to group 1, for example,
press the group button repeatedly until the middle LED above the
group button lights up).
3. Hold down the group button for approx. 5 seconds. The feedback
display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The
bulb will signal that it has been selected by increasing and decrea-
sing its brightness. The bulbs will blink in the order in which they are
stored in the tint remote control.
5. Hold down the group button again until the selected bulb starts to
blink again.
The group display for group 1 will also light up.
6. Using the group button, select (if necessary) the group to which you
would like to add the bulb while the feedback display still is blinking
red/green.
The selected bulb will be assigned to default group (=group 1) if group
button is not pressed at all. After approx. 10 seconds, the bulb will
be added to the selected group and the feedback display will stop
blinking. Wait this long, not pressing any buttons during this time.
The procedure will then end and you can use the extended group as
normal.
