Muller Elektronik TANK-Control II, Инструкция по установке и эксплуатации

Страница: 49 / 66

"Tank Control II" menu - Filling and operation
Controlling external devices
9
30252060-02-EN V2.20161017 49
▪ You can set a PWM value. The PWM value entered indicates the percentage of maximum filling
pump speed during operation, in this case: 10%.
▪ You can set the on-time that the filling pump should take to reach the specified PWM value. The
same time is used to switch the filling pump off, in this case: 5 seconds.
Using a ball valve
You can use a ball valve in two ways:
▪ Without additional filling pump
▪ With additional filling pump
The settings that you can enter differ according to the method of use of the ball valve. The following
settings are available:
Function icon or
key Meaning
Change mode
Change status
Set the start time of the ball valve and filling pump relative to one another
Set the stop time of the ball valve and filling pump relative to one another
Set time-controlled start or stop
Ball valve with filling pump
If you are using a ball valve with additional filling pump, you will see the following screen:
Screen: Ball valve with filling pump
Mode Stop time
Start time
Status [
➙
45]
9.5.5
www.ROLTRONIK.pl