Mueller Mi.Net, Руководство по эксплуатации

Страница: 3 / 8

3
MI.NET® MOBILE TRANSCEIVER
Installation
SETUP
VEHICLE INSTALLATION
strain relief for the cable to protect
the point of connection at the
antenna base.
4. Route the cable through a door
or window (B) . Make sure that
there is enough slack in the cable
so that opening or closing the
door does not pull on either end of
the cable.
Make power and cable
connections
1.
Using the supplied power cord /
adapter, plug the adapter into the
vehicle’s 12-volt power supply and
connect the other end to the port
labeled POWER at the back of the
transceiver, see
Diagram 2
.
Mount the antenna on top
of the vehicle
1.
Attach the gasket and
assembled antenna to the antenna
base. DO NOT yet attach the
antenna cable.
IMPORTANT: Ensure the
gasket and antenna whip
remain tightened and in place
to avoid moisture intrusion in
the unit. DO NOT remove the
gasket or antenna, or water
intrusion may occur, potentially
causing failure.
2.
Place the assembled antenna on
the roof of the vehicle. Ensure the
antenna base is positioned so the
arrow on the antenna base points
toward the front of the vehicle.
NOTE: DO NOT place the antenna
assembly within 12" of any other
antennas on the vehicle. If there
are other antennas on the vehicle,
orient the antenna assembly
(if possible) such that all the
antennas are in a straight line
along the direction of travel.
3.
Attach the cable to the antenna
base. Wrap the antenna cable one
turn around one of the magnets
(A.) . The objective is to provide
2. Using the supplied USB cable,
connect the USB 2.0 Type B to the
jack labeled COMPUTER in the rear
of the transceiver and the USB Type
A plug into the laptop computer.
3. Attach the antenna’s connector
into the Mobile transceiver’s port
labeled RF.
Notes:
• Before meter reading, ensure
there is nothing in the USB
port used for upgrades (labeled
USB-A). A flash drive left in the
port may be damaged, or can
cause damage to the port.
• After connecting to 12V power,
startup may take up to two
minutes while the transceiver
performs boot-up processing.
Do not attempt to use the
transceiver for any purpose
while it is booting up.
• If the data USB from the
laptop becomes disconnected
at any time, the transceiver
goes to low power mode in
approximately two minutes
with 12V power applied. When
both are disconnected, the unit
powers down completely in
approximately two minutes.
A.
B.
Install the Mobile Transceiver in a
safe place within the vehicle, for
example on the dashboard or under it or buckled into a seat with a seat
belt holding it in place. A standard
AV mounting bracket is provided on the bottom of the transceiver in the
event a permanent mounting
is desired.
DIAGRAM 2. REAR OF TRANSCEIVER SHOWING CONNECTIONS
USB Port for Firmware
Upgrades ONLY
To
Mi.Net M
Antenna
GPS Antenna
Port NOT USED
To 12V
Auxiliary
Power
To Laptop Running
EZMobile