KIROVETS K-744R1, K-744R2, K-744R3, K-744R4 tractors
93
No.
K-744R1 tractor
K-744R2, K-744R3, K-744R4 tractors
2.
Perform a 1.5-hour running-in of the tractor on
doubled wheels with tightening of additional
wheel fasteners every 30 min.
Perform an 8-hour running-in of the tractor on
doubled wheels with tightening of additional wheel
fasteners every 2 hours.
3.
During shift maintenance (once in every 8
–10
engine hours of tractor operation) tighten the
additional wheel fasteners to the stop.
During shift maintenance (no more than 10 engine
hours of tractor operation) tighten the additional
wheel fasteners to the stop.
4.
Tractor main wheels shall be tightened at the first
maintenance (M-1, once in every 125 engine
hours).
Tractor main wheels shall be tightened at the first
maintenance (M-1, once in every 125 engine
hours).
Tyre operation record-keeping
Maintain record-
keeping for each tyre separately. To this end, a “Tyre operation registration
card” is to be established, which is the main document characterizing the tyre operation in case
of reclamation, write-off to scrap as well as in other cases. The internal pressure in tyres should
be registered in the “Log-book for registration of measurements of the internal air pressure in
tyres”. The results are recorded in the log-book in accordance with the type operation rules for
tractors.
6.4 Connection of the hydraulic system of agricultural machines, implements and
vehicles to the tractor hydraulic system
The connection is provided by means of eight hydraulic fast-coupling cutoff clutches (Fig.26)
installed on the rear semi-frame of the tractor and connected to four service sections of
hydraulic distributor.
The connection of hydraulic system of the tractor and agricultural implement shall be performed
in the following sequence:
– connect hoses 6 to the hydraulic system of agricultural implement;
– pull hose 9 to the stop; in doing so, balls 7 will settle opposite the groove of
closing sleeve 3;
– install valve 5 into clutch 1 to the stop;
– release hose 9, clutch 1 under the action of spring 8 will return into the initial
position;
– make sure of reliability of fixing valve 5 in housing 1.
Содержание K-744R1
Страница 2: ...MTZ KIROVETS tractors K 744R1 K 744R2 K 744R3 K 744R4 2...
Страница 107: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 107 Driving shaft friction clutch I...
Страница 109: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 109 Driving shaft friction clutches II and III...
Страница 111: ...KIROVETS K 744R1 K 744R2 K 744R3 K 744R4 tractors 111 Driving shaft friction clutch IV...
