MTD WOLF Alpha 95.165 H, Руководство пользователя

Страница: 25 / 284

25
Troubleshooting
EN
Troubleshooting
WARNING !
Risk of injuries or material damage
¾
In case of doubt always consult a specialist workshop.
¾
Park the device prior to each inspection or prior to working on the cutting blades.
¾
Prior to all work on the device, protect yourself from injury by
-Switching the motor off.
-Removing the ignition key.
-Engaging the parking brake.
-Waiting until all moving parts have come to a complete standstill.
-Wait until the motor has cooled down.
-Remove the spark plug connector from the motor so that unintentional motor starts are prevent-
ed.
Problem Possible cause Remedy
Starter is not turning.
Safety locking system has been triggered.
Sit down on the driver's seat, step down
fully on the brake pedal and engage the
parking brake.
Switch the PTO off.
Attach the grass collector or the optional
deflector to the device.
Battery not properly connected.
Connect the red cable to the (+) pole of
the battery, and the black cable to the (-)
pole of the battery.
Starter is not turning.
Empty or weak battery.
Check and charge the battery.
If necessary, replace the battery.
Fuse has tripped.
Replace the fuse.
If the fuse trips again, look for the cause
(usually a short circuit).
Loose ground cable between motor and
frame.
Connect the ground cable.
Start is turning but motor is
not starting.
Incorrect position of choke and throttle.
Actuate the choke. Set the throttle
to .
Carburettor not receiving any fuel; fuel
tank empty.
Top up with fuel.
Defective or soiled spark plugs.
Check the spark plugs (see motor
manual).
No ignition sparks.
Have the ignition checked in a work-
shop.
Motor producing smoke.
Too much motor oil in the motor.
Switch the device off immediately.
Check the motor oil level.
Motor defective.
Switch the device off immediately.
Have the motor inspected in a work-
shop.
Strong vibrations.
Damaged motor shaft or defective cutting
blade.
Switch the device off immediately.
Have defective parts replaced in a
workshop.
Cutting mechanism does
not eject any grass or cut
is not clean.
Low motor speed. Rev up!
Excessive driving speed. Set a lower driving speed.
Cutting blade blunt.
Have the cutting blade sharpened or
replaced in a workshop.
Motor is running but cutting
mechanism is not mowing. V-belt torn.
Have the V-belt replaced in a workshop.