MTD WOLF Alpha 95.165 H, Руководство пользователя

Страница: 15 / 284

15
Assembly
EN
DANGER !
Risk of poisoning and injury posed by
battery acid
¾
Wear protective goggles and protective
gloves.
¾
Avoid skin contact with battery acid.
¾
If battery acid is sprayed in your face
or eyes, wash the area exposed
immediately with cold water and seek
medical attention.
¾
If you have swallowed battery acid, drink
lots of water and seek medical attention.
¾
Store batteries out of the reach of
children.
¾
Never tip batteries over, as battery acid
may run out.
¾
Return any leftover battery acid to your
dealer or a disposal company.
Attention!
¾
Pay attention to the assembly sequence for
connecting and disconnecting the battery.
¾
Put the battery into operation only with the
battery pole cover (in the form of a cover flap on
the positive terminal, or as a complete battery
protection cover, depending on the design)
attached.
Note
The battery is located in the battery compart-
ment on the rear of the device
F
. To open
the battery compartment, remove the two
tommy nuts and take off the cover.
Installation
Ga
Î
First connect the red cable (+ / positive pole)
1
.
Î
Then connect the black cable
(- / negative pole)
2
.
Î
Attach the battery pole cover.
Removal
Î
Detach the battery pole cover.
Î
First disconnect the black cable (- / negative pole).
Î
Then connect the red cable (+ / positive pole).
In the event of a maintenance-free / sealed
battery (type 1) being supplied
(Battery without sealing plugs)
WARNING !
Electrolyte fluid may even discharge from
sealed batteries
Â
Risk of injury and fire
¾
Avoid tipping the battery over
Î
Prior to initial commissioning, charge up the bat-
tery using a 12-Volt battery charger (maximum
charge current 6 Amperes) for one to two hours.
Î
Once charging is over, first detach the mains con -
nector of the charger.
Î
Then disconnect the battery (also refer to the
charger's operating instructions).
Attention!
¾
Pay attention to the notes in the operating
instructions for the charger.
In the event of an unfilled battery being delivered
(type 2)
(Battery with sealing plugs)
Î
Remove the sealing plugs from the battery
cells
Gb
.
Î
Fill each cell slowly with battery acid up to 1 cm
below the fill opening.
Î
Leave the battery standing for 30 mins.
Î
Check the acid level, and top up with battery acid
if necessary.
Î
Prior to initial commissioning, charge up the bat-
tery using a 12-Volt battery charger (maximum
charge current 6 Amperes) for one to two hours.
Î
Once charging is over, first detach the mains con -
nector of the charger.
Î
Then disconnect the battery.
Î
Attach the sealing plugs to the battery.
Î
Install the battery in the device.
Î
First connect the red cable (+), then the black
cable (-).
Attention!
¾
Pay attention to the notes in the operating
instructions for the charger.
Note
Later only fill the battery with distilled water
(inspect every two months).
Attaching the grass collector
Î
Read and observe the separate operating instruc-
tions 'Grass collector'.